Sp Command List - NEC Express5800 1080Xd User Manual

USERS_GUIDE_1080XD_hw
1.4.7.4.4

SP command list

The following list includes the SP commands in categories.
System Control
CMD Command name
Shut down System power
DF
(override)
DN Shut down System power
DP System Dump
PC Power Cycle
RS Cold Reset System
UP Bring up System
Save system CMOS/
SR
NvRAM
NML mode:
m:
(Reference) System state transition and System control commands
DC OFF
The iSP turns off the DC power of the specified
partition without notifying the SW(OS) even if it is
running..
If the specified partition is in S0 state, the iSP only
generates the SCI(POWBTN). Otherwise, the iSP
turns off the DC power directly.
The iSP generates the INIT signal to the specified
partition. SW(OS) will enter its dump routine.
The iSP turns off the DC power of the specified
partition without notifying the SW(OS) even if it is
running, turns on the DC power, initializes HW
and hands off the control to the BIOS.
The iSP initializes the specified partition without
notifying the SW(OS) even if it is running.
The iSP turns on the DC power of the specified
partition and initializes HW and hands off the
control to the BIOS. The BIOS will boot the
Operating System.
Save and/or restore the system
CMOS/NvRAM.
Availability or Unavailability of operation in the normal mode. X means
available.
Availability or Unavailability of operation in the master iSP.
UP/PC
DN/DF
DC ON
Not running
Function
DF
PC
Ready
SW running
RS
UP/PC/RS
NML iSP
mode state
X m
X m
X m
X m
X m
X m
X m
DN/DP
(only trigger)
1-33