NEC SuperScript 610 User Manual page 87

Print Status Window
Paper Jam
Paper has jammed inside the printer,
making it impossible to continue print-
ing. Open the printer's cover. Remove
all paper. Close the cover.
Silentwriter SuperScript 610 will start up
again automatically once the jam has
been cleared. In most cases, the printer
will reprint the page jammed before
continuing with the rest of your docu-
ment.
Paper Size Error
The printer is loaded with sheets of a
different paper size than what the
software has been setup to handle. You
need to load a different size paper, or
change paper size selection in your
printer setup screen.
Power Off or Cable Problem
NEC SuperScript software can't find
your printer. This error may be caused
by:
1. the printer is off.
2. the printer's parallel cable is not
installed properly.
3. a problem exists within the
connection or the parallel cable is
not good.
Verify the printer is powered on and the
left printer status light (LED) is lit or
blinking. Check the parallel cable is
correctly connected to the printer and the
PC.
Warming Up
Wait until the engine has finished warm-
ing up.
5–5