Table of Contents
Advertisement
Adhesive
Labels
Table 6-3 Label Specifications
ITEM
Caliper
Construction
Curl
Electrical surface resistivity
Electrical volume resistivity
Finishing
Fusing capability
Packaging
Shelf life
Smoothness
Selecting Paper and Media
All adhesive label paper properties must match the
specifications listed in Table 6-3.
SPECIFICATION
No more than 0.19 mm (0.0075 inches)
The label stock must provide good toner adhesion.
No adhesive can be on the external label surfaces.
General label attachment/die-cutting cannot allow
for peeling during transport, printing, or electrical
fusing. Labels should cover the entire carrier
sheet.
Zero curl toward image side, minimum 30-degree
radius curl toward opposite side. Curl must be
within specifications after heating at 200˚ C
(392˚ F) for 0.1 seconds.
10
2.0 to 15 10
ohms/square.
11
1.2 to 15 10
ohms-centimeter.
Cut sheets must be within ±0.8 mm of nominal,
corners at 90˚ ±0.2˚ .
Cannot scorch, melt, offset, or release hazardous
emissions when heated to 200˚ C (392˚ F ) for 0.1
seconds.
Moisture-proof wrap.
One year (minimum) stored at 22˚ C (71.6˚ F) at
50% relative humidity.
100 to 250, Sheffield scale.
6–13
Advertisement
Table of Contents
