Table of Contents
Advertisement
2–30
Setting Up
5. You will be prompted to choose 50-sheet hopper
or 200-sheet hopper. Unless you have purchased
the optional 200-sheet hopper, select the standard
50-sheet hopper.
6. Tell the setup program which parallel port you
wish to use: LPT1, LPT2, or LPT3. The setup
program only shows you the port names available
on your system. The default is LPT1.
Later, after the installation, you can select a
different port by using the NEC SuperScript
Print Manager (see Chapter 4).
Advertisement
Table of Contents
Need help?
Do you have a question about the SuperScript 610 and is the answer not in the manual?
Questions and answers