Reset Output; Basic Zone Configuration; Expanded Zone Configuration - NAPCO Gemini GEM-X255 Installation Instructions Manual

WI1093A 12/01

RESET OUTPUT

15
Reset Output can be activated depending on the programming options selected (see GEM-
RESET
X255 Programming Instructions). Connect the device controlled by the programmable output
OUTPUT
between terminal 15 (+) and terminal 14 (-).

BASIC ZONE CONFIGURATION

The basic zone configuration for the GEM-X255 is 8 zones. Connect as shown above to terminals 16-27. Normally Closed
(N.C.) devices may be wired in series or Normally Open (N.O.) devices may be wired in parallel. Use the 2.2K Ohm
end-of-line (E.O.L.) resistor in each zone, if selected in programming (refer to the GEM-X255 Programming Instructions).
Zones 1-8 can be selected for a "Fast Loop Response (10ms or 50 ms)" or a "Normal Loop Response (750 ms)". Other
zone options include Zone Type (Entry/Exit, Interior, 24 Hour Protection, Trouble and Fire), Instant, Chime, Area Selection
and Relay Output selection.

EXPANDED ZONE CONFIGURATION

The GEM-X255 Control Panel may be expanded up to 96 zones. This may be accomplished by adding 88 zones to the
basic 8 zone configuration. Hardwired zone expanders include: GEM-EZM4 (4 additonal zones per module), GEM-EZM8
(8 additional zones per module) and GEM-RP1CAe2 Keypad (4 additional zones per keypad). Wireless zone expanders
include: GEM-RECV8 (8 additional zones per receiver), GEM-RECV16 (16 additional zones per receiver) and GEM-
RECV96 (88 additional zones per receiver). Wireless transmitters include: GEM-TRANS2, GEM-KEYF, GEM-SMK,
GEM-PIR, GEM-DT and GEM-GB.
L
NAPCO Security Systems
Additional Zones are numbered 9-96.
GEMINI
SYSTEM ARMED
01/01/97 12:00AM
N EX T/YES
A 1 2 3 E
D
PR IO R /NO
B 4 5 6 F
AREA
C 7 8 9 0 G
CO MPUTERIZED SE CURITY SYSTEM
R
GEM-RP1CAe2
(2 LINE LCD KEYPAD)
X
GEM-X255 Installation Instructions
!
Page 15