Checking The Motherboard Setup - Supero SuperServer 5015A-PHF User Manual

S S
UPER ERVER 5015A-PHF User's Manual
2-5

Checking the Motherboard Setup

After you install the 5015A-PHF in the rack, you will need to open the unit to make
sure the motherboard is properly installed and all the connections have been
made.
Accessing the Inside of the System (Figure 2-3)
1. First, grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click").
2. Remove the fi ve screws that hold the chassis cover in place.There are two
screws on each side of the chassis, and one screw on the back.
3. Once the screws have been removed, lift the cover upward to remove it from
the chassis.
Checking the Components
4. Your 5015A-PHF server system may have come with system memory already
installed. Make sure all DIMMs are fully seated in their slots. For details on
adding system memory, refer to Chapter 5.
5. If desired, you can install an add-on card to the system. See Chapter 5 for
details on installing a PCI add-on card.
6. Make sure all power and data cables are properly connected and not blocking
the airfl ow. See Chapter 5 for details on cable connections.
Warning: Except for short periods of time, do NOT operate the server without the
cover in place. The chassis cover must be in place to allow proper airfl ow and prevent
overheating.
2-6