System Fans; Drive Bay Installation/Removal - Supero SuperServer 5015A-PHF User Manual

6-3

System Fans

The SC502L is a fan-less chassis, which results in extremely quiet and energy-
effi cient operation. The only fan in the system is located on the heatsink for the
embedded processor.
6-4

Drive Bay Installation/Removal

Installling a 3.5" SATA Drive (Figure 6-3)
1. Power down the system and unplug the AC power cord.
2. Remove the chassis cover as described on page 2-6.
3. Use screws to secure the drive directly into the left side of the chassis as
shown in the fi gure.
Installling 2.5" SATA Drives (Figure 6-4)
1. Power down the system and unplug the AC power cord.
2. Remove the chassis cover as described on page 2-6.
3. Use screws to secure the drive into the hard drive bracket:
For two drives the bracket is p/n MCP-220-00044-0N.
For one drive the bracket is p/n MCP-220-00051-0N.
4. Use screws to secure the bracket/drive assembly into the left side of the
chassis as shown in the fi gure.
Warning: Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the Supermicro
Web site at http://www.supermicro.com/products/nfo/storage.cfm
Chapter 6: Advanced Chassis Setup
6-3