Smb (I 2 C) Bus To Pci Slots; Tpm Support Enable; Watch Dog Enable/Disable; Power Force On Enable/Disable - Supero SuperServer 5015A-PHF User Manual

2
SMB (I C) Bus to PCI Slots
Jumpers JI 2 C1 and JI 2
to connect the System Management
Bus (SMB) to the PCI-E PCI slot. The
default setting is Disabled. See table
on the right for jumper settings.

TPM Support Enable

JPT1 allows the user to enable TPM
(Trusted Platform Module) support to
enhance data integrity and system
security. See the table on the right for
jumper settings. The default setting
is Enabled.

Watch Dog Enable/Disable

Watch Dog (JWD) is a system monitor
that can reboot the system when a
software application hangs. Close pins
1~2 to reset the system if an applica-
tion hangs. Close pins 2~3 to generate
a non-maskable interrupt signal for
the application that hangs. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
the BIOS.

Power Force On Enable/Disable

Jumper JPF allows you to enable or
disable the Power Force On function.
If enabled, the power will always stay
on automatically. If this function is
disabled (the normal setting), the user
needs to press the power button to
power on the system.

VGA Enable/Disable

JPG1 allows the user to enable the
onboard VGA connector. Close Pins
1~2 to use this function. The default
setting is Enabled.
Chapter 5: Advanced Motherboard Setup
C2 allow you
5-17
2
I C to PCI-Slots
Jumper Settings
Jumper Defi nition
On Enabled
Off Disabled
TPM Support
Jumper Settings
Jumper Setting Defi nition
1-2 Enabled
2-3 Disabled
Watch Dog
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset
(default)
Pins 2-3 NMI
Open Disabled
Power Force On
Jumper Settings
Jumper Setting Defi nition
Open Normal
Closed Force On
VGA Enable
Jumper Settings
Pin# Defi nition
1-2 Enabled (default)
2-3 Disabled