Table of Contents
Advertisement
User Setting Screen
• DPMS:
• BackLight:
• OSD Position:
• OSD User Time Out: Used to set the time for the on-screen display to disappear.
• Front Key Lock:
• Input Skip:
• PinP Position:
• PinP Select:
• DVI EQ/OP-DVI EQ: This cable compensation function helps suppress noises when
When set at ON, the display power management function puts
the unit in the power-save mode if a selected input has no
signal and no key is operated for longer than 30 seconds. The
backlight is automatically turned off.
Power OFF/ON: To be resumed by feeding a signal or operating
a key.
Used to change the backlight brightness of the LCD panel.
The adjustable range is from 0 to 255.
Used to select the on-screen display position. The numerical
settings allow the following display positions.
1: Upper right, 2: Top center, 3: Upper left, 4: Lower right, 5:
Lower left
The OSD disappears in any of the following time settings.
10s: 10 seconds, 30s: 30 seconds, 60s: 60 seconds, OFF: No
time setting
With this function, the OSD turns itself off if the OSD setting
key is not operated within a preset time.
At the ON position, all the front keys are inoperative. No
operation is possible.
To unlock the front keys, hold down the "EXIT" key and turn
on the power. The unlock status is automatically saved.
At the ON position, the non-signal input is skipped when the
input signal is selected with INPUT1 or INPUT2.
Used to select the picture-in-picture display position. The
numerical settings allow the following display positions.
1: Upper left, 2: Upper right, 3: Lower left, 4: Lower right
Used to select the picture-in-picture mode. There are four
modes to choose from: PinP1, PinP2, SBS1 and SBS2.
the DVI is connected using a long cable and suffers from noises.
The DVI EQ setting is to adjust the standard input, and the
OP-DVI EQ setting for an optional board.
11
5. Operation
Advertisement
Table of Contents
