AGA TOTAL CONTROL TC3 Installation Manual page 9

110/120V 60 Hz FLEXIBLE CORD AND PLUG PARALLEL TYPE. The appliance when installed,
must be electrically grounded in accordance with local or regional codes.
An electrical socket must be provided within 5 feet of the LH side of the appliance and easily
accessible to the user to disconnect. Do not position socket above the appliance.
Take special care when cutting holes in wall or floor. Electrical wires may be behind the wall or
floor covering and could cause an electrical shock if you touch them.
Locate any electrical circuits that could be affected by the installation of this product and
disconnect power circuit.
This appliance is equipped with a (three prong) grounding plug for your protection against a
shock hazard and should be plugged directly into a proper receptacle. Do not cut or remove
the grounding prong from this plug.
Do not have a fuse in the neutral or grounding circuit. A fuse in the neutral or grounding circuit
could result in electrical shock.
Do not use an extension lead with this appliance.
Check with a qualified electrician if you are not sure the appliance is properly grounded.
Failure to follow these instructions could result in death or serious injury.
9