Wpa(2)-Psk - ZyXEL Communications WAP3205 User Manual

Table 25 Universal Repeater Mode: Wireless LAN > Universal Repeater: Static WEP
LABEL
WEP Key 1 ~
WEP Key 4
Apply
Reset

8.6.3 WPA(2)-PSK

Figure 46 Universal Repeater Mode: Wireless LAN > Universal Repeater: WPA(2)-
PSK
The following table describes the labels in this screen.
Table 26 Universal Repeater Mode: Wireless LAN > Universal Repeater: WPA(2)-
PSK
LABEL
Universal Repeater Parameters
Enable
SSID
MAC Address
(Optional)
Security Mode
WAP3205 User's Guide
DESCRIPTION
The WEP keys are used to encrypt data. Both the WAP3205 and the
access point must use the same WEP key for data transmission.
If you chose HEX, enter 10 or 26 hexadecimal characters in the range of
"A-F", "a-f" and "0-9" (for example, 11AA22BB33) for a 64-bit or 128-bit
WEP key respectively.
If you chose ASCII, enter any 5 or 13 ASCII characters (case sensitive)
ranging from "a-z", "A-Z" and "0-9" (for example, MyKey) for a 64-bit or
128-bit WEP key respectively.
You must configure at least one key, only one key can be activated at any
one time.
Click Apply to save your changes back to the WAP3205.
Click Reset to reload the previous configuration for this screen.
DESCRIPTION
Select this option to have the WAP3205 connect to the specified access
point.
Enter the name of the access point to which you are connecting.
Enter the MAC address of the access point to which you are connecting.
Select WPA-PSK or WPA2-PSK if the access point to which you want to
connect uses WPA-PSK or WPA2-PSK.
Chapter 8 Universal Repeater Mode
89