Table of Contents
Advertisement
APPLYING POWER
The M12 A coded power connector is keyed, where the mating connection from the power supply can
be made only when the male and female ends are lined up properly.
When the power is first connected all LED's will flash ON Momentarily.
Verify the Power LED stays ON (GREEN).
Note: Either V
or V
can be connected to power for minimal operation. For redundant power
1
2
operation, V
and V
must be connected to separate DC Voltage sources. The power cord should be
1
2
limited to less than 10 meters in order to ensure optimum performance.
Recommended 24V DC Power Supplies, similar to:
100VAC/240VAC:
N-Tron NTPS-24-1.3, DC 24V/1.3A
9
(Revised 2010-11-15)
Advertisement
Table of Contents
