Advertisement
,
Make wire attachments
at STBs.
-
Split and strip wire ends to be connected
as shown Fig. 3-6.
-
Loosen terminal screws.
-
Insert wire under flat plate and tighten screw.
It does not matter which wire, white or
striped, goes on which terminal Fig. 3-7.
,
Make wire attachments
at power head.
-
STBs are connected
to terminals #3 and
#4 on power head Fig. 3-8. tt does not
matter which wire, white or striped, goes on
which terminal.
4.
Check the following.
,
Ensure that no part of door or its hardware
is
in path between lenses of source
and sensor.
,
Ensure that tops of lenses are between 5"-6"
above the floor Fig. 3=9. The brackets are
flexible, and can be adjusted slightly if needed.
(See Illustration on page 3 for a full view of
Safe-T-Beam ® location.)
Advertisement
