Advertisement
•
Slide a collar [11] over exposed
end of
screw on "middle" rail as far as it wilt go.
Fig. 1-8.
•
Engage "hook" on "middle"
rail with "hook"
on "first" rail section.
Fig. 1-9.
•
Slide collar toward power head so that it
now covers
hooks. Fig. 1-10.
•
Snap a clip [12] onto screw behind
collar to
hold collar in place. Fig. 1-11.
•
Slide middle rail against first rail.
•
Place rail clamp [7] on each side of joint
where
rails meet. Match up holes in clamps
with holes in rail. (Edge with lip is bottom
of clamp.)
•
Secure
rail clamps with 4 bolts [8] and 4
nuts [9], hand tight only. Fig. 1-12.
[12]
Clip
5/16" Flange nut
[8]
5/16" Shoulder bolt w/flange
Advertisement
