Advertisement
1.
Mounting
brackets.
,
Mark both sides of garage door frame or wall
5" above floor. Fig. 3=1.
,
Hold bracket [38] against door frame or wall.
-
Check if brackets extend out from wall far
enough, so tongue of bracket is beyond
door, tracks or any door hardware.
-
If not:
a. STB bracket extensions
are available
at local dealer.
b. Blocks of wood, etc. may be substituted
for extensions.
.
Center bracket on your mark Fig. 3=2.
,
Fasten each with 2 screws [40]. Fig. 3=2.
(Tongues should point toward each other.)
[4o]
#10-16 x 1-1/4"
2.
Mounting
STB source
and sensor.
,
If garage has only one garage door.
-
Determine which side of garage receives
most direct sunlight Fig. 3=4, and place Red
LED here whenever
possible Fig. 3-4.
.
For multiple doors.
-
Preventing crossed signals is critical.
-
Place source and sensor modules on
adjacent doors facing in opposite directions
Fig. 3-4.
•
Slide source/sensor
onto tongue of bracket
until it clicks into place Fig. 3-3.
TWO
DOOR
GARAGE
GARAGE
THREE
DOOR
GARAGE
=
Wiring.
,
Route wire [29] using either method shown
Fig. 3-5.
,
Securely fasten wires to ceiling and walls as
you go using insulated staples [30].
-
Staples should be snug only. Staples which
are too tight can cut wires.
[30]
Insulated staple
L
Dashed
Line = striped
wire
Solid
Line = white
wire
I
I
I
[]
Advertisement
