Advertisement
1.
Run wire from power head to wall control
,
Find location for wall control:
-
In sight of door and away from moving parts.
-
At least 5 feet from floor, so small
children cannot reach it.
•
Route wire from wall control to power head.
•
Use staples to fasten wire to ceiling and wall.
NON_!: Use only _J;_p e_; nc uded
2.
Split wires at ends and remove 1!2 inch of
insulation from end of each Wire. Fig. 4=1.
3.
Attach wires to terminals.
Fig. 4=2, Fig. 4=3.
,
Loosen (Do Not Remove) screws from
Terminals
at power head and wall control
•
Connect wires to power head
-
White wire to terminal # 1
-
Striped wire to terminal #2
-
Tighten screws
•
Connect wires to wall control
-
Striped wire to terminal "B"
-
White wire to terminal "W"
-
Tighten screws
4.
Mount wall control. Fig. 44.
.
For Wall Console or Wall Button.
-
Use pan head screws [34].
5.
Mount entrapment
warning
label. Fig. 44.
.
Remove protective
backing.
•
Stick label to wall next to wall control.
-
Tacks or staples may be required on some
rough texture surfaces.
f<:,: y d®aFef' ONLY ONE OF YOUR _LL
CON'f\POLS
_;_Y BE THE L GH'_)
T'_'_E. f _m,_ have a Z_h%_d
ws
eet_f/_oh s
:y'_:, :r add _;_'®t:_af ¢ot:_g'oJs m_;
be
Advertisement
