Advertisement
7.
Attach
"end"
rail section
[3C].
•
Attach
"end" rail in same way as "middle" rail
(step 5). ("End" rail section
screw
has "hook"
on one end only.)
8.
Flip power
head/rail
assembly
over
(upside
down), so that entire length of screw
is visible
from above.
9.
install
carriage
stop
[6].
•
With bent tabs facing up, slide carriage
stop
into rail. Fig. 1-13.
•
Slide carriage
stop along rail until it rests
against
power
head.
10. install
carriage
[10].
•
Place emergency
release
lever in released
position.
Fig. 1-14.
•
Make sure arrow on side of carriage
(Fig. 1-14) is pointing
away from power
head. (Emergency
release
lever wilt be
facing power head.)
•
Slide carriage
into rail. Fig. 1-15.
NOFi_iJ!/Oa_%Q:e oa,,',,be t_;'ed _ s s _:_mp®p;s_/
_?#L £V#c.® ®me;s[?®oc}f ;,'<#_t_sse hive;" M ®g#g®d
11. Flip assembly
right
side up.
(Rail resting on carriage.)
12. Attach rail strap [13].
•
Place rail strap against end of rail so that
attached
stud passes in front of end of rail.
Fig. 1=16.
•
Line up rail strap holes with rail holes.
•
Secure with 2 bolts [46] and 2 nuts [9].
13. Make sure rail assembly
is resting
straight
and level.
•
FULLY TIGHTEN
ALL BOLTS AND NUTS IN
RAIL ASSEMBLY.
[91
5/16" Flange nut
[4S]
5/16" x 3/4" Hex head bolt
power
head
Advertisement
