Genie IS Series Quick Start Manual

Download this manual

IS, ISL, IC, H

Series

Includes

and SERIES II Electronics

Included Wall Control MUST be installed prior to operation of this Garage

Door Operator

Safe-T-Beam

Safety Reverse System Must be installed to close door

NOTE: Your Residential Operator comes with a Rail Assembly

which is standard for up to a 7 foot 6 inch high door. An extension

kit for an 8 foot high door is available.

For Answers and Assistance:

1.800.354.3643

or visit www.geniecompany.com

SAVE THIS MANUAL FOR FUTURE REFERENCE

3511035556

Remote Control

Need help?

Do you have a question about the IS Series and is the answer not in the manual?

Page 1 3511035556 ¤ ® IS, ISL, IC, H Series Includes Remote Control and SERIES II Electronics Included Wall Control MUST be installed prior to operation of this Garage Door Operator Safe-T-Beam ® Safety Reverse System Must be installed to close door NOTE: Your Residential Operator comes with a Rail Assembly which is standard for up to a 7 foot 6 inch high door.
Page 2 The Genie Company recommends that you read and fully understand all information and instructions contained herein before choosing a “do-it-yourself ” installation. Any questions should be directed to the Genie Company or an authorized Genie Dealer. ( The issue numbers below refer to the circled numbers in the illustrations on page 3.
Page 3 TYPICAL SECTIONAL DOOR INSTALLATION ADDED TYPICAL HEADER BRACKET SUPPORT MOUNTING BOARD BRACKET BRACES 36” POWER CORD 120V GROUNDED OUTLET EXTENSION SPRING TORSION SPRING SAFE-T-BEAM ® TYPICAL 1-PIECE DOOR INSTALLATION 1-PIECE DOOR SECTIONAL DOOR...
Page 4 RECOMMENDED TOOLS TABLE OF CONTENTS SECTION PAGE PRE-INSTALLATION CHECK LIST ....2-3 Carpenter’s level TOOLS REQUIRED ......4 SAFETY FEATURES .

Isl seriesIc seriesH series