Advertisement
Limit switch adjustments
must be completed
before running contact reverse test.
,
Test contact reverse.
.
Open door using wall control.
.
Lay 2" x 4" board*
on floor in center of garage
door opening.
Fig. 7-3.
.
Close door using wall control.
-
Door should stop and reverse
within 2 seconds of contacting
the board.
-
If door does not reverse properly:
a. Decrease
closing force a small amount
by turning the "CLOSE" force adjustment
screw slightly counterclockwise.
b. Test contact reverse again.
c. Repeat steps a. and b. until contact
reverse works properly.
*If you don't have a 2" x 4" board handy, any object
1-1/2 inches high that can withstand
being hit by the
garage door without sustaining
damage is fine.
NOD!:!!:
do_:y _ _!_:_?P_::_WX7
bu_ _t_;__;t
f_;W
'CLOSE
_4_ _,_wfch mu_
be mov®d c_2_e' o
d%_ o P:
1.
Install/replace
battery
Fig. 8-1.
.
Using a pen or similar object, gently push in
on tab.
.
Cover snaps open. Remove old battery.
.
Observe polarity markings
(+,-)inside
battery compartment.
.
Match new battery to polarity markings
and
instal new SS_,EVEREAD_
A23, 12 Volt battery.
•
Replace battery cover.
2.
Attach
visor clip Fig. 6-1.
.
Slide clip in slot on back of remote control.
-
Snap in place.
Advertisement
