GarrettCom Magnum 3000 Installation And User Manual page 21

Magnum 3000 Stackable Hubs
When installing a PM into the Bonus Port slot of the Magnum 3024, use the
16-pin header labeled P1 (also labeled RPM) on the circuit board corresponding to ports
13-24. The red stripe of the connector cable should connect to pin 1 of header P1.
NOTE:
Use J1 (AUI) and for Basic AUI ports
Use P1 (RPM) for PMs
NOTE: The PM will still function if connected to header J1/B of the circuit board
corresponding to ports 1-12. However, this is not advised, as the port will not be
recognized by an SNMP Agent (if one is present).
Figure 2.5d: Magnum 3024 internal layout with configured Bonus Port
CBL-AUI
When the RPM-AUI is factory configured as a bonus port, it is implemented
with CBL-AUI, an AUI
connector with a ribbon cable, to
the 16-pin header J1 (AUI) on
the main board (Shown in both
figure 2.5a and 2.5b). Since the
AUI functionality is build onto
the main board, using CBL-AUI
is identical to the RPM-AUI. GCI recommends that RPM-AUI units should not get
installed in the bonus port of both 3012's and 3024's.
www GarrettCom com . .
Bonus port for optional
PM card (BPM shown)
PM Ribbon cable with 16 pin connector.
(Included only when PM is factory
May be ordered separately as part # CBL-PM)
CBL-AUI
14
Installation and User Guide (07/06)
J1
(AUI)
P1
(RPM)
Pin 1 (red)