Grounding Instructions; Product Record - Kenmore 790.79012 Use & Care Manual

Important Safety Instructions
SELF CLEANING OVENS
• Clean in the self-cleaning cycle only the parts listed in this
Use & Care Guide. Before self cleaning the oven, remove the
broiler pan and any utensils or foods from the oven.
• Do Not Use Oven Cleaners--No commercial oven cleaner or
oven liner protective coating of any kind should be used in or
around any part of the oven.
• Do Not Clean Door Gasket--The door gasket is essential for
a good seal. Care should be taken not to rub, damage or
move the gasket.
IMPORTANT SAFETY NOTICE
The California Safe Drinking Water and Toxic Enforcement Act
requires the Governor of California to publish a list of
substances known to the state to cause cancer, birth defects or
other reproductive harm, and requires businesses to warn
customers of potential exposure to such substances.
GROUNDING INSTRUCTIONS
_'IV=V-'I:t_II_[¢ll Avoid fire hazard or electrical shock. Do not
use an adapter plug, an extension cord, or remove grounding
prong from electrical power cord. Failure to fellow this warning
can cause serious injury, fire or death.
_'IV=V-'I:t_II_[¢ll This appliance is equipped with a 3-prong
grounding plug for your protection against shock hazard and
should be plugged directly into a properly grounded receptacle.
DO NOT cut or remove the grounding prong from this plug.
For personal safety, the range must be properly grounded. For
maximum safety, the power cord must be plugged into an
electrical outlet that is correctly polarized and properly
grounded.
If a 2-prong wall receptacle is the only available outlet, it is the
personal responsibility of the consumer to have it replaced with
a properly grounded 3-prong wall receptacle installed by a
qualified electrician.
_o not, under any
circumstance, cut,
remove, or bypass
_he grounding prong.
Grounding type
wall receptacle
Power supply cord
with 3-prong
grounding plug
See the INSTALLATION INSTRUCTIONS packaged with this
range for complete installation and grounding instructions.
Product Record
(See Serial Plate Location below)
Model No. 790.
Serial No.
Date of Purchase
READ AND SAVE THESE INSTRUCTIONS.
Save your sales receipt for future reference.
Serial Plate Location
You will find the model and serial number printed on the serial
plate. The serial plate is located on the right side of the oven
front frame behind the warmer drawer compartment panel.
Please see the illustration for exact location. Remember to
record the serial number for future reference (See Product
Record above).
Conversion to Liquefield Petroleum Gas (also
known as L.P. Gas)
The natural gas range is designed to allow for conversion to
Liquefied Petroleum (L.P.) Gas. Contact Sears Service for
assistance. The L.P. Conversion Kit is provided with this
range and is located on the left lower REAR (back side)
panel of the range. Before installing the kit be sure to follow
the L.P. Installation Instructions carefully.
Open warmer drawer.
Sedal plate location Is hem
5