Rear Panel; Figure 2-2 Rear Panel; Table 2-2 Rear Panel Connections - Motorola DCH6416 Installation Manual

2 OVERVIEW

Rear Panel

The rear panel contains a switched power outlet; connectors for video, audio, and RF
cabling; data output; and modem and data interface connectors. Some connectors
are not enabled and require the support of application software.

Figure 2-2 Rear panel

RF2 CM
IN IN
RPT OUT

Table 2-2 Rear panel connections

1 Cable In—Connects to cable signal from your service provider
2 RF Out—Ch 3/4 modulated audio/video (SDTV) to TV or VCR
3 M-Card—Input slot for CableCARD (M-Card device only). If the M-Card
was pre-installed in the factory there will be a cover attached over the slot.
4 Serial—Service only
5
S-Video—Connects to S-Video
6 Digital Audio (S/PDIF)—Provides Dolby
7
YPbPr—Component video output
8
Video/Audio—Composite Video
9
HDMI—High-Definition TV
10 eSATA*—External Serial ATA disk interface
11 Ethernet*—Network connection
12 USB* 2.0—High-Speed peripheral device connection
13 IEEE-1394—Audio and video device connection
14 Power cord connector
*The availability of certain features is dependent upon application support.
S VIDEO
™
M Card DEVICE ONLY -
RF1
IN
RF OUT
CABLE
IN SERIAL
(SDTV)
(HDTV)
(SDTV)
(HDTV)
V
Y
-
L
Pb
ETHERNET
R
Pr HDMI
OUT IN
USB
DIGITAL AUDIO eSATA
VIDEO AUDIO /
input of TV or VCR
®
Digital 5.1 audio or PCM output
/Audio L/R inputs and outputs
connector
7
SWITCHED
105 125V -
60Hz
4A MAX
500W MAX
IEEE 1394