Setup - Dell 1710n - Laser Printer B/W Service Manual

Setting
Print Quality
Test Pages
Reset Photo-
conductor
Counter

Setup

Use the Setup menu to configure how the printer formats the end of a line
depending on the computer system being used.
Menu item
Demo Mode
Auto CR
After LF
Auto LF after
CR
Use setting to
Help isolate print quality problems, such as streaking. Four
pages print to help evaluate print quality:
• A text page with printer information, cartridge information,
current margin settings, and a graphic.
• One page is gray with graphics, one is black, and one is
blank.
Return the photoconductor counter to zero.
The replace photoconductor message should be cleared only
when the photoconductor kit has been replaced.
Use setting to
Put printer into demo
mode where internal
sheets print with each
press of .
To deactivate, turn the
printer off, and re-enter
configuration group. Set
to deactivate.
Specify whether the
printer automatically
performs a carriage return
after a line feed control
command.
Specify whether the
printer automatically
performs a line feed after
a carriage return control
command.
Diagnostic aids—E238, E240, and E240n
Values
Values
Deactivate (default)
Activate
Off (default)
On
Off (default)
On
3-7