Service Error Codes - Dell 1710n - Laser Printer B/W Service Manual

Service error codes

Service error codes are generally non-recoverable except in an intermittent
condition when you can POR the printer to temporarily recover from the
error condition.
Service error codes (9xx)
Error Description
900 Service
RIP software
902 General engine
software failure
905 Interface violation by
the Paperport device
917 Transfer roll
920 Fuser error
Indicates that the fuser
is below temperature
when printing.
921 Fuser error
Indicates that the fuser
is below proper
temperature during
standby or idle time.
922 Fuser error
Fuser failed to reach
standby temperature.
923 Fuser is too hot during
printing or when printer
is idle.
924 An open circuit has
been detected in the
fuser thermistor circuit.
Action
Server firmware problem. Contact the
next level of support.
An unrecoverable engine software error.
Reset the printer (POR). If the problem
continues, replace the controller card.
The likely cause is a faulty HVPS. It may
also indicate a problem in the transfer roll
area. Go to "Transfer roll service
check" on page
Go to "Fuser service check" on
page 2-87.
Go to "Fuser service check" on
page 2-87.
Verify line voltage to the fuser. Go to
"Fuser service check" on page
Go to "Fuser service check" on
page 2-87.
Check cabling and connectors. Go to
"Fuser service check" on page 2-87
the thermistor.
Diagnostics—E340 and E342n
2-111.
2-87.
for
2-65