Dell 1710n - Laser Printer B/W Service Manual page 102

Service manual
Hide thumbs Also See for 1710n - Laser Printer B/W:
Table of Contents

Advertisement

Sub error codes
First 6 bytes sub
error code data
(xx can be any
value)
84 00 22 x1
x2 00
84 01 22 x1
x2 00
84 x1 30 x2
x3 x4
84 1x 2D x2
x3 x4
84 xx 00 x1
x2 x3
2-70
Service Manual
Explanation
Indicates the media reached the image
point before EP leading edge state
machine was ready.
(x1=leading edge of media state,
x2=trailing edge of media state)
Media reached the image point before EP
trailing edge state printer was ready.
(x1=EP leading edge state, x2=EP trailing
edge state.)
Motor head transport motor error.
(x1=motore type, x2=error code,
x3=TimWatchingHallCount,
x4=TimeWatchingHallPeriod.)
Misidentified no gap jam. Engine detected
no gap at the manual feeder sensor,
attempted to open the gap by stopping
the feed rolls, trailing edge was seen at
the input sensor, manual feeder sensor is
no longer covered.
(x1+x2=page ahead's expected length,
x3+x4=Page ahead's measured length)
This code indicates that the input sensor
is still actuated from the first sheet, and
the second sheet is ready to arrive at the
sensor.
(x1=FsyncFall flag for Page Ahead,
x2=media source, x3=last measured gap
at input sensor).)
• Check the printer input sensor and flag
for correct operation. The flag should
operate freely.
• Check for debris in the area of the input
sensor.
• Check the area of the transfer roll and
input to the fuser for anything that
might cause the paper to remain over
the input sensor.
Possible
error
message
200
200
200

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents