Devices To The Pc In Connection - Loewe Connect 26 LED Operating Instructions Manual

External devices

Devices to the PC IN connection

You can connect a PC to the PC IN socket for example and thus use the
TV screen as a monitor.
➠ When connecting a PCs or accessory device to the PC IN socket of the
TV set, set the output signal on your PC first so that it matches one of
the signals in the table on page 92.
Connecting the device
Switch off all equipment before connecting.
Connect the device to the TV set's PC IN socket with a VGA cable.
Connect the analogue audio signal of the PC to the AUDIO IN jack on
the TV set with a stereo cable.
PC
AUDIO VGA
Alternatively, connect the digital audio output of the PC or accessory equip-
ment to the AUDIO DIGITAL IN socket of the TV set with a cinch cable.
The digital audio input can be assigned to the PC IN socket by TV menu
Connections Miscellaneous Assign digital audio input (see page 81).
If your PC has an HDMI interface, you can also connect the PC via the
HDMI socket to your TV set (see page 76).
Depending on the version of the HDMI connection on the PC, the audio
signal is also transmitted via the HDMI connection.
If this is not the case, connect the analogue or digital sound as described
above. See the appropriate operating manual for further information
about the version of the HDMI interface on your PC.
.
- 78
TV set
PC IN AUDIO
IN
Connection example of a PC
Playback from the device
Call AV selection.
Select PC IN socket,
OK switch over.
PC picture adjustment (only possible with certain signals)
In this menu you can set the position (vertical, horizontal) and the phase
length of your PC.
MENU: Call TV menu.
 Select Picture,
 go to the menu line below.
 Select more ...,
OK call.
 Select PC IN / HDMI display,
 go to the menu line below.
Select the desired setting,
 go to the menu line below.
Make settings.
Set Signal type at PC IN (only possible with certain signals)
MENU: Call TV menu.
 Select Connections,
 go to the menu line below.
 Select Miscellaenous,
 go to the menu line below.
Select and set Signal type at PC IN:
RGB or Ycc / Ypp
The colours will not be shown correctly if the wrong
standard is set.