Loewe Connect 26 LED Operating Instructions Manual page 26

Initial installation
Setting options for the satellite system
(max. 4 satellites on DiSEqC multiswitch):
Settings
DiSEqC
multiswitch
 Select and adapt settings for the DiSEqC
multiswitch.
Repeat rate The refresh rate determines how often a DiSEqC
command is output. A refresh is only necessary with
cascaded systems.
Control The control voltage controls the switching of the
voltage polarisation level (horizontal/vertical) in non-DiSEqC
capable components (e.g. control of single LNBs via
DiSEqC multiswitch).
22kHz signal The 22kHz signal controls the switching between high
and low band in the Band setting. The Position setting
controls the selection of the satellites in non-DiSEqC
capable components.
Toneburst The Toneburst controls the selection of the satellites in
non-DiSEqC but toneburst capable components with the
Position and Option settings.
OK Proceed
Satellite
selection
 Select Satellite 1 ... Satellite 4,
 select satellites from list,
OK Proceed.
LNB
frequencies
 Set LNB frequencies.
You do not normally need to change the values.
OK Proceed.
(with Setting options for DVB-S reception (continued)
on page 27).
- 26
Setting options for the satellite system
(DiSEqC one cable communal system):
DiSEqC one
cable
communal
system
 Select DiSEqC single cable communal installation.
OK Proceed.
Satellite
selection
 Select satellites from list,
OK Proceed.
LNB
frequencies
 Set LNB frequencies.
Normally, you do not need to change the values for
high and low band, unless the LNC (LNB) of your
satellite system uses a different oscillator frequency
(important for the frequency display).
OK Proceed.
Manual
registration
(for socket
ANT SAT)
 Select and adjust settings for the DiSEqC single
cable communal installation.
Transmission Select the desired transmission channel and the corre-
channel /frequency sponding transmission frequency.
PIN protection If your system is designed for it, it is possible to protect
your used transmission data from use by other subscrib-
ers with a PIN.
OK Proceed.
(with Setting options for DVB-S reception (continued)
on page 27).