Loewe Connect 26 LED Operating Instructions Manual page 24

Initial installation
Setting options for DVB-C reception:
If you have not selected a DVB-C antenna in the antenna
selection: Continue with Setting options for DVB-S recep-
tion (see right hand column).
The normal DVB-C settings are derived from the selection
of the location and do not need to be changed.
Settings
 Select and adapt settings for DVB-C reception.
Encrypted You can state whether coded stations are to be searched
stations for in the search/update.
scrambled stations. However, these stations can only be
received in connection with a CA module and the appro-
priate Smart Card.
on page 55.
If a CA module with a SmartCard is already plugged in for
the station search, all the stations which this module can
descramble are also saved when no is preset.
Search If you want to run the station search independently of
method the channel grid, select frequency search for the search
method.
Start
The DVB stations are only searched for in the frequency
frequency
range above the start frequency.
Network ID Only change these defaults if you are familiar with other
symbol rates and types of modulation or if you have to
Symbol rate specify the network ID for your cable network. In the
case of small cable networks fed directly from the satel-
QAM lite, the rate of 6900 might have to be replaced by 6111.
modulation Your cable provider has the information you need.
OK Proceed.
- 24
Select yes to save all found
Handling of the CA module is described
Setting options for DVB-S reception:
If you have not selected a DVB-S antenna in the antenna
selection: Continue with Setting options for all types of
reception on page 28.
The normal DVB-S settings are derived from the selection
of the location and do not need to be changed in most
cases.
Select
satellite
installation
 Selecting the satellite system.
Specify how you receive which satellite(s) (single
satellite or type of satellite system). Ask your dealer
if required.
Single Reception of a single satellite via a connected LNC (LNB).
satellite See page 25 for settings.
2 satellites Reception of two different satellites with two LNCs (LNBs)
on 22 kHz which are connected to the TV set by a 22 kHz switchbox.
switchbox See page 25 for settings.
2 satellites Reception of two different satellites with two LNCs (LNBs)
on toneburst which are connected to the TV set by a toneburst switch.
switch See page 25 for settings.
Max. 4 The TV set controls a DiSEqC multiswitch to which up to
satellites four LNCs (LNBs) for different satellites are connected.
on DiSEqC See page 26 for settings.
multiswitch
DiSEqC Select setting if the TV set is connected to a DiSEqC
one cable single-cable system (according to EN 50494). Several Sat
communal receivers can be connected to one Sat cable. See page 26
system for settings.
other Select setting if the TV set is connected to a single-cable
communal system (without DiSEqC). Several Sat receivers can be
installation connected to one Sat cable. Unlike a DiSEqC single-cable
system there are restrictions in the range of certain recep-
tion frequencies in single-cable community systems. See
page 27 for settings.
OK Proceed
(to the appropriate page of the satellite system).