Loewe Connect 26 LED Operating Instructions Manual page 27

Initial installation
Setting options for the satellite system
(other communal installation):
Select single
satellite
 Select satellite,
OK Proceed.
LNB
settings
 Select and adapt settings.
LNC Normally, you do not need to change the values for high
frequency and low band, unless the LNC (LNB) of your satellite
system uses a different oscillator frequency (important
for the frequency display).
If your set is connected to a single-cable system without
Supply voltage
external voltage supply, you can connect the antenna
supply (13V or 18V / max. 450mA).
OK Proceed.
(with Setting options for all types of reception on
page 28).
Setting options for DVB-S reception (continued):
Test reception
After you have made the previous settings, you should
receive picture and sound of the selected satellites (only
possible for Astra1 and HOTBIRD).
OK Proceed.
Settings
 Select and adapt settings.
If several satellites are received, the following settings
must be made for every satellite. The scope of the settings
may differ depending on the selected satellite.
You can state whether coded stations are to be searched
Encrypted
for in the search/update.
stations
scrambled stations. However, these stations can only be
received in connection with a CA module and the appro-
priate Smart Card.
on page 55.
If a CA module with a SmartCard is already plugged in for
the station search, all the stations which this module can
descramble are also saved when no is preset.
Search If you want to run the station search independently of
method the channel grid, select frequency search for the search
method.
Symbol rates The symbol rates are specified by the satellite provider
and do not normally need to be changed.
OK Proceed.
Select yes to save all found
Handling of the CA module is described
27 -