Loewe Connect 26 LED Operating Instructions Manual page 23

Hide thumbs Also See for Connect 26 LED:
Table of Contents

Advertisement

Initial installation
Selecting
DVB-S can only be selected if the set is equipped with
antennas
a satellite tuner. Depending on which antenna(s) was
(continued)
(were) selected, the appropriate settings are called later
during the routine.
OK proceed.
Subtitle and
audio
languages
(DVB)
 Select desired languages and alternative
languages for subtitles and audio for DVB
programmes (see page 53).
OK Proceed.
Logical
Channel
Number
 Accept Logical Channel Number no / yes.
In various countries, digital stations (DVB-T, DVB-C,
DVB-S) are transmitted with a preset channel
number per station, known as "Logical Channel
Numbers" – "LCN".
If you indicate yes here, the specified programme
numbers will be adopted as station memory loca-
tions and the stations of the preferred signal
sources sorted by LCN. There may be gaps in the
numbering of the station list depending on the LCN.
OK Proceed.
Depending on which antennas (DVB-T, DVB-C, DVB-S)
were selected, the appropriate settings appear
below.
Setting options for DVB-T reception:
If you have not selected a DVB-T antenna in the antenna
selection: Continue with setting options for DVB-C recep-
tion on page 24.
Settings
 Select and adapt settings for DVB-T reception.
You can state whether coded stations are to be searched
Encrypted
stations
for in the search/update.
scrambled stations. However, these stations can only
be received in connection with a CA module and the
appropriate Smart Card.
described on page 55.
If a CA module with a SmartCard is already plugged in for
the station search, all the stations which this module can
descramble are also saved when no is preset.
Search
If you want to run the station search independently of
method
the channel grid, select frequency search for the search
method.
OK Proceed.
Supply voltage
 Select supply voltage no / yes.
Use a DVB-T antenna that requires a supply voltage
(active antenna) and which is not already supplied
via a power adapter, then select yes (5V) for the
antenna's power supply.
How to align your DVB-T antenna is described on
page 29.
OK Proceed.
Select
yes
to save all found
Handling of the CA module is
23 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents