Safety Instructions; For Connecting Up And Functioning; For The Oven; For The Core Temperature Probe - Kuppersbusch EEB 970.0 Instructions For Use And Installation Instructions

Table of Contents

Advertisement

Notes on safety

for connecting up and functioning

Only Küppersbusch fitted hobs have been designed and tested for use
on top of a Küppersbusch fitted oven. Other hobs must not be used.
The cookers may only be connected to the mains, maintained and repai-
red by a qualified electrician according to valid safety regulations. Work
carried out incorrectly places your safety at risk.
Do not put the appliance into operation unless it has been built in!
The surfaces of the oven are very hot when in operation. Always keep
children away!
Connection leads of electrical appliances may not get jammed in the
hot oven door.
Steam and/or pressure cleaning machines must not be used to clean
the oven! The appliance could be damaged in such a way that your life
could be at risk.
Warning! This appliance must be earthed!
The cooker is to be used only for the preparation of food in the home.

for the oven

When carrying out repairs and replacing oven light bulbs, the cooker
must be disconnected from the mains (switch off the fuse).
Never store any objects in your oven which could cause a hazard if the
oven is unintentionally switched on.
Take special care when working in the hot oven. Use a dish cloth, oven
gloves or similar.
The oven door must close well. In the event of damage to the door sea-
ling, hinges, sealing surfaces or to the glass pane, do not use your coo-
ker until it has been repaired and checked by a qualified and authorised
trained installer.
Caution! When opening and closing the oven door, do not reach into
the hinge. Risk of injury!
Always close the oven door completely when preparing food in the oven.

for the core temperature probe

Only use the original core temperature probe.
Do not jam the cable of the core temperature probe in the oven door.
Remove from the oven when not in use.
®
The ökotherm
®
The ökotherm
catalyst immediately cleans the oven air of fat, odours and
suspended matter during roasting and baking. It converts odours and fat fumes
in the oven itself into odourless moist air. No energy is consumed but released.
Clean air leaves the oven. Fat deposits on the furniture are avoided.
If the cleaning effect diminishes, you can simply regenerate the ökotherm
catalyst (see page 18).
catalyst
Before using the oven the first time

Disposing of packaging material and old appliance

Dispose of the transport packaging in such a way that it does not impact
on the environment.
If the appliance is purchased in Germany, the dealer who sold you the app-
liance will dispose of the transport packaging for you. Recycling the packa-
ging saves raw materials and reduces the amount of waste disposed app-
liances still contain useful materials. Dispose of your old appliance at a
collection point for recycling useful materials. Before disposing of your old
appliance ensure that it cannot be used any longer. This will prevent misuse.

Cleaning for the first time

Remove foreign matter and packaging.
Before preparing food for the first time, thoroughly clean the oven interior
and the baking trays, grease drip tray, gridiron, core temperature probe
etc. with a damp cloth and some detergent.
Heating the oven:
- Close the oven door,
- heat the oven with : top heat and bottom heat with rapid-heating fun-
ction at 220 °C temperature for 60 minutes, at the same time keep the
kitchen well ventilated.
Setting the time
The clock continuously displays the time. It runs independently of the oven
functions. You set the time as follows:
- Touch the glass on the right beside the time display until a signal
is emitted. The numbers flash.
- Now set the time using the control knob.
About 5 sec. after the setting has been made, the time display stops flashing.
The time setting has been made.
To reset the clock, you have to repeat this procedure.
The clock can be used as a minute minder.

Setting the minute minder

The minute minder can be used without a cut-out function if the oven
is not being used.
®
- Keep the button
- Setthe time with the control knob.
The pre-set time in minutes appears on the left of the display and at
the same time as a time of day in the time display.
- On expiry of the pre-set time an acoustic signal is emitted.
- To turn off the signal, touch the button minute minder
26
pressed.
.
EEB 970.0

Advertisement

Table of Contents
loading

Table of Contents