Table of Contents
Advertisement
Installation
Notes on installation
The statutory regulations and connection conditions of the local
electricity utility must be observed in full.
Disconnect the appliance from the power supply for connection, repairs
and changing the oven bulb. Pull out plug or switch off fuse.
If you want to install the EEB 970.0 in the corner of an L-shaped kit-
chen so that the left side of the oven is flush with the other kitchen
line, there must be a space of at least 15 cm between the left side of
the oven and the other line front.
In accordance with heating testing standards, the appliance corresponds
to Safety Class Y.
The furniture into wich the oven is to be installed must be temperature
resistant to 100 °C. This applies in particular to veneer, edging, plastic
surfaces, adhesives and lacquers. The fronts of the surrounding furnitu-
re must be temperture resistant to at least 70 °C.
It is imperative to install the appliance horizontally on an even plank.
The plank must not bend.
If the furniture unit is not attached to the wall, attach it using a conven-
tional fixing angle.
The appliance mains socket must be located outside the installation
area.
The appliance is fitted with a plug, and must only be connected to a
properly installed socket outlet with earthing contact.
The installation of the socket or replacement of the connecting cable
must only be carried out by a qualified electrician in accordance with
current regulations. If the plug is no longer accessible subsequent to in-
stallation, an all-pole disconnecting device must be present on the in-
stallation side with a contact gap of at least 3 mm in order to comply
with current regulations.
The protective conductor must be long enough so that, if the strain relief
device fails, it is not subjected to tension until after the live conductors
of the connection cable.
Full protection against electric shocks must be ensured by the method of
installation.
Dimensions for installation
EEB 970.0
Electric connection
Connection
with earthed shock-proof plug to socket.
Socket must have a 16 A fuse.
Rated consumption
at 230 V: 3.5 kW
at 235 V: 3,6 kW
Connection value
230 - 240 V, 50 Hz
Installation in kitchen furniture
The holding plates are supplied and must be installed as follows on both
insides of the cupboard before installation of the appliance:
5. Insert plug into socket and push appliance into the cupboard niche until
it engages.
While doing so, do not jam the appliance connection cable! The con-
necting cable must not touch the rear side or base of the appliance.
41
1. Place holding plate at a
distance of 280 mm
from the cupboard
bottom edge with the
embossing against
the cupboard and
mark and drill the
rear holes.
2. Position the holding pla-
tes so that the front
holes lie over the bo-
res.
3. Fasten assembly plate
on the cupboard with
the enclosed screws.
4. Suspend the clipses at
the left and right of
the appliance and
screw into place.
Hide quick links:
Advertisement
Table of Contents
