The toprack isdesigned forcups, g lasses, andsmaller items.
Many items, upto11"(28cm), f it inthetoprack. ( See
loading p atterns shown.)
NOTE: The features onyour d ishwasher
rack may vary from the
Fold down the extra shelf on the left-hand or right-hand side of
the top rack to hold additional cups, stemware or long items such
as utensils and spatulas.
NOTE: The features on your dishwasher may vary from those
10 place setting
!2 place setting
Place items so open ends face down for cleaning and
Load glasses in top rack only. The bottom rack is not
designed for glasses. Damage can occur.
Place cups and glasses in the rows between tines. Placing
them over the tines can lead to breakage and water spots.
China, crystal, and other delicate items must not touch each
other during dishwasher operation.
Damage may occur.
Load lightweight plastic items in the top rack only. Only
plastic items marked "dishwasher
safe" are recommended.
Load plastic items so the force of the spray does not move
them during the cycle.
To avoid chipping, do not let stemware touch other items.
Small bowls, pans, and other utensils can be placed in the
top rack. Load bowls in the center section for best stability.
Use this extra capacity basket in the back of the top rack to hold
spatulas, wooden spoons, and similar items.
two position top rack
You can raise or lower the top rack to fit tall items in either the top
or bottom rack. Raise the top rack to accommodate
items up to
9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or
lower the top rack to accommodate
items up to 11" (28 cm) in
both the top and bottom racks. Adjusters are located on each
side of the top rack.
To raise the top rack
Lift the rack on both sides until the rack is level.
NOTE: The top rack must be level.
To lower the top rack
Depress both tabs on rack adjusters, as shown above, and slide
the rack back to its original position.
Removable top rack
The removable top rack allows you to wash larger items
such as stock pots, roasters, and cookie sheets in the bottom
To remove the top rack
1. Pull the rack forward slightly to access clips.
2. While pressing the ridges in, push back on the clip until the
outer side releases. Slide the clip to the inside of the track
edge to remove the clip.
3. After removing both clips, pull rack out.