Configuration Menu; Config Beep; Config Lamp - AOR AR8200 Manual

(14) Configuration menu

The configuration (CONFIG) menu is used to set fundamental operating parameters and other variables
which do not appear in any other menu heading.
BEEP
LAMP
CONTRAST
POWER-SAVE
AUTO PWR-OFF
REMOTE BPS
RMT-ID
FREQ DISP
WRITE PROT
OPENING MESSAGE

14-1 CONFIG BEEP

The AR8200 emits confirmation 'beeps' while the keypad and side
keys are used. A 'HIGH' pitched beep indicates correct operation
while a 'LOW' pitched beep indicates that an error or unexpected
entry has taken place. The volume of the beep is independent of
the main volume control and can be separately defined. It is
recommended that the beep facility be enabled, especially in the
early days while gaining familiarity of the receiver.
Beep is setup in the CONFIG menu. To access the config
menu
config menu is "BEEP", the default is beep on with a volume level of 09. Use the main dial or
keys to vary beep level between the range of OFF and 01 to 09 with 09 being the loudest. The
key may be used as a short cut to 05.
to accept the data and return to a standard display. Alternatively
to abort entry or

14-2 CONFIG LAMP

The AR8200 is equipped with high intensity green LEDs to illuminate the LCD and front panel keypad
when operating in areas of low level lighting.
While the AR8200 is switched on and connected to an external power source such as the charger
or d.c. lead, the lamp will be PERMANENTLY ON and cannot be switched off . The lamp will go out
when the AR8200 is switched off (when the batteries are being charged etc).
Confirmation & error tone
LCD & keypad illumination
LCD contrast adjustment
Delay & cycle power save
Auto inactivity power off
RS232 baud rate
Computer control address
Frequency readout on/off
Global write protect
Change the power-up message
. The first item in the
to move to the next item on the config menu (LAMP).