Searching Unlinked Banks; Expert Search Operations - AOR AR8000 Operating Manual

13-8 Searching a program search bank which is not specified in BANK
LINK
It is still possible to SEARCH a single deselected bank by manually bypassing
the BANK LINK programming. To SEARCH any deselected bank simply key
the desired identifying bank letter through the keypad.
If initially the bank selected is not linked and does not contain data, the sub
menu "SRCH SELECT" will appear. Select the desired bank identifying letter
(which does contain data) using the keypad and [.Aa] key as appropriate. The
receiver will search only the selected single unlinked bank over and over and
will not attempt to search the group of banks as specified in BANK LINK.
13-9 Additional SEARCH options in EXPERT status
It is possible to alter the sequence of scanning events when in EXPERT status
depending upon the SEARCH CONFIGURATION as defined in the "SET
SEARCH" sub menu.
There are 4 search parameters which may be changed to suit your preferences
and requirements. The list of search defaults is shown below:
SEARCH TYPE
DELAY
AUDIO
FREE
LEVEL
* It is possible to mix combinations of all four parameters. *
It is strongly recommended that NEWUSER mode is used during
familiarisation of the AR8000, use EXPERT status only if you have fully
familiarised yourself with all operations.
To select EXPERT configuration the CONFIGURATION menu is used. To
access the menu press [FUNC] [LOCAL] and the "INITIAL SET" menu will be
displayed.
Select the NEWUSER/EXPERT option of the fourth
line of the LCD, the cursor will be to the right of the
"NEWUSER" setting which is the default. To change
the setting to "EXPERT" rotate the [DIAL] (on the top
panel) one click, the direction is unimportant. The
legend "EXPERT" confirms selection.
The new setting may be saved by pressing [ENT] at
this point.
If you have selected "EXPERT" status then further options become available by
pressing the [DOWN] key. These include AUTO-STORE, POWER-SAVE and
REMOTE. These options are covered later in the operating manual.
NEWUSER
2.0 seconds
OFF
OFF
OFF
EXPERT
0.1 - 9.9 seconds/OFF/HOLD
OFF/ON
01 - 99 seconds/OFF
0 - 7 /OFF