Memory Swap Mode - AOR AR8000 Operating Manual

The third line will alternate between MODE and STEP while the fourth line will
alternate between TXT and FREQUENCY so that easy identification of the
desired memory channel may be made.
Once you have chosen the desired memory channel to be moved press [ENT].
The "original" memory channel number moves to the left hand side of the
second line of the LCD and a symbol "==>" points to another memory channel
toward the right of the second line of the LCD. The cursor is positioned over
the new memory channel. This new memory channel number is the location
where you want to move the memory data to. Use the [DIAL] or keypad to
select the memory channel where you want to move the memory data to.
The original data WILL be deleted leaving the original channel blank and the
memory data will be moved to the new memory channel.
For example, let's assume that memory channel "A00" contains the frequency
92.7 MHz with the mode WFM, step set to AUTO, attenuator OFF and
alphanumeric comment (as previously programmed in section 8-1 of this
manual). You decide to MOVE this memory data to memory location "B31".
Press [FUNC] [8] to access the "SET EDIT-CH" menu.
Move the cursor to the left of the "MOVE-MODE" option using the UP/DOWN
keys or [DIAL] then press [ENT] to access the "MOVE-MODE" sub menu.
Key in the original channel number which you wish to copy using the keypad
[A] [0] [0] or rotate the [DIAL] to locate the channel number "A00". Press
[ENT] to select channel number "A00" which is to be copied.
Key in the channel number of the location to where the memory data is to be
copied using the keypad [B] [3] [1] or rotate the [DIAL] to locate the channel
number "B31". Press [ENT] to select channel number "D15" where the data
will be copied to.
Memory "A00" will now be blank (deleted) but memory channel "B31" will
contain the memory data 92.7 MHz, WFM, AUTO step, attenuator off and
alphanumeric comment.
8-6 SWAP-MODE
SWAP-MODE is used to exchange data between two specified memory
channels. The process is similar to MOVE-DATA in section 8-5 of this manual
but the contents of the "target" memory location are simultaneously copied
back to the "original" memory location.
First make sure that you have data stored in both the memory channels to be
"swapped".
For example, program 88.3 MHz into memory channel A00 and 99.5 MHz into
memory channel A01 (entering frequencies and memory data as shown in
sections 6-4 & 7-1 of this manual).