AOR AR8000 Operating Manual page 83

SELECT PROGRAM SEARCH BANK FOR PROGRAMMING: To access the
SEARCH PROGRAM menu press [FUNC] [6]. The legend "SRCH PROG" will
be displayed on the top line of the LCD.
The second line of the LCD will display the legend "BANK" followed by the
search bank identifier to the right. The highlight cursor will be flashing over a
search bank identifying letter (the current search bank
parameters will be displayed on the third and fourth
lines of the LCD in a scrolling format, if there is no
data programmed the data areas will display "- - -").
Select program search bank "J" by pressing [0J] or
use the UP/DOWN keys or rotate the [DIAL]. When
"J" is displayed press [ENT] to select bank "J" for
programming.
The LCD top line alternates between "SRCH PROG" and "BNK-J" to indicate
programming is in process.
CHANGE MODE: The selection symbol ">" appears on the second line of the
LCD along with available modes. The symbol "#" indicates the current
selection.
Use the UP/DOWN keys or rotate the [DIAL] to until the ">" symbol is to the
left of and pointing at the mode "NFM". Press [ENT] to accept the mode
selection.
Note: If AUTO is selected, the "STEP SET" menu option will be skipped as the
data will be taken from the AUTO-MODE bandplan data programmed into the
AR8000 microprocessor.
ATTENUATOR SETTING: The highlight flashing cursor moves to the
attenuator selection point on the second line of the LCD with the legend "ATT"
shown to the left indicating that attenuator setting is required. The top line of
the LCD displays the indications "SRCH PROG" and "BNK-J NFM" to indicate
that the program search data input menu is currently being used and the mode
has been earlier selected as NFM.
The options are "OFF or ON". Use the UP/DOWN keys or rotate the [DIAL]
until the legend "OFF" is displayed. Press the [ENT] key to accept the
attenuator setting.
STEP SET: The highlight flashing cursor moves to the step selection point on
the second line of the LCD over the legend "STEP" with an additional legend
"SRCH PROG / BNK-J NFM" displayed on the top line.
The standard options are: 0.05 kHz (50 Hz), 0.1 kHz (100 Hz), 0.2 kHz (200
Hz), 0.5 kHz (500 Hz), 1.00 kHz, 2.00 kHz, 5.00 kHz, 6.25 kHz, 9.00 kHz,
10.00 kHz, 12.50 kHz, 20 kHz, 25.00 kHz, 30 kHz, 50 kHz, 100.00 kHz, 200.00
kHz, 250 kHz, 500.00 kHz.