Memory Change Mode - AOR AR8000 Operating Manual

Press [FUNC] [8] to access the "SET EDIT-CH" menu.
Move the cursor to the left of the "SWAP-MODE" option using the UP/DOWN
keys or [DIAL] then press [ENT] to access the "SWAP-MODE" sub menu.
Key in the "first" channel number which you wish to SWAP using the keypad
[A] [0] [0] or rotate the [DIAL] to locate the channel number "A00". Press
[ENT] to select the first channel number "A00" which is to be swapped.
Key in the "second" channel number which you wish to SWAP using the
keypad [A] [0] [1] or rotate the [DIAL] to locate the channel number "A01".
Press [ENT] to select the second channel number "A01" which is to be
swapped.
Memory channel "A00" will now have the new frequency 99.5 MHz with the
mode WFM, step set to AUTO, attenuator OFF and no alphanumeric
comment. Memory channel "A01" will now have the new frequency 88.3 MHz
with the mode WFM, step set to AUTO, attenuator OFF and no alphanumeric
comment.
In other words, the memory channel data has been SWAPPED between
memory locations.
8-7 CHANGE-MEM
"CHANGE-MEM" is the sub menu used to edit all the data contained in each
memory channel on an individual basis. This data comprises of FRE-
QUENCY, TUNING STEP, STEP OFFSET, RECEIVE MODE, ATTENUATOR
and ALPHANUMERIC ACCOMPANYING TEXT.
To select the "CHANGE-MEM" sub menu first access the SET EDIT-CH menu
by pressing [FUNC] [8]. Use the UP/DOWN keys or [DIAL] until the cursor is
to the left of the "CHANGE-MEM" option then press [ENT].
The top line of the LCD will alternately flash between "SET EDIT-CH" and
"CHANGE-MEM" to indicate that a sub menu has been selected.
The cursor will be positioned over the memory bank identifier (LETTER). Use
the [DIAL] or keypad to select the memory channel which you would like to
edit.
The third line will alternate between MODE and STEP while the fourth line will
alternate between TXT and FREQUENCY so that easy identification of the
desired memory channel may be made.
Once you have chosen the memory channel to be edited press [ENT].
Data may now be edited, follow the menu pressing [ENT] to accept each
change or skip over a parameter change completely. Once all data sections
have been entered the display reverts to 2VFO mode.