Other Lcd Indications & Error Messages - AOR AR8000 Operating Manual

transmissions (you can usually remove the aerial to determine this).
Alternatively the AR8000 (like all receivers) will produce spurii in certain places
such as 76.8 MHz and 49.725 MHz as examples. You may use the PASS and
AUDIO SCAN/SEARCH facilities to reduce their annoyance to a minimum.
The display blinks and changes
Ensure that the PRIORITY facility is not engaged. If it is, a letter "P" will be
displayed on the first line of the LCD.
Receiver does not switch on
In using NiCad batteries, charge them using the charger provided or connect
the receiver to a vehicle cigar lighter socket using the DC lead provided. If you
are using dry batteries, replace them with a fresh set.
If this does not help
If the above does not help, please contact your supplier for assistance.
20-3 Other LCD indications and error messages
"BEEP" & "BOOP"
The keypad usually produces a high pitch "beep" when the correct key or
sequence is followed. Should an inappropriate key be pressed, a lower pitch
"BOOP" will be produced. It is possible to switch the beep & boop On/Off
using the CONFIG menu [FUNC] [LOCAL].
"BATTERY LOW" or "BATT ERR"
If using NiCad batteries, charge them using the charger provided or connect
the receiver to a vehicle cigar lighter socket using the DC lead provided. If you
are using dry batteries, replace them with a fresh set.
"NOT FOUND"
The memory channel or bank specified cannot be found. This may happen in
SCAN mode with no memory channels with valid data (empty bank) or when
no memory channels have the selected receive mode. The message may also
be displayed in SELECT SCAN if no channels have been "tagged". The
receiver will return to 2VFO mode after approximately 3 seconds.
"MAX ERROR"
This error message will be displayed if you attempt to "tag" or select more that
100 select scan channels. The error message will also be displayed if you
attempt to PASS more than 50 frequencies in a search bank.