Deleting Memory Channels & Banks; Deleting Individual Memory Channels; Deleting Complete Memory Banks - AOR AR8000 Operating Manual

8-8 Deleting memory channels and banks
It is possible to delete memory channels on an individual basis or delete a
whole memory bank in one go. In fact, the delete key has many operations
depending upon what operating mode (2VFO, SCAN or SEARCH) the receiver
was in prior to the selection of delete using the key sequence [FUNC] [9].
The deletion of memory data presumes that you have previously programmed
memory channels which you now wish to delete! Once you have deleted
memory channel and memory bank data it cannot be restored so follow the key
sequence carefully.

8-9 Deleting individual memory channels

First place the AR8000 into "M.RE" mode. Switch On the receiver and press
the [SCAN] key once (unless it is in SCAN mode in which case you should
press [2VFO] followed by [SCAN]).
Select the memory channel which you wish to delete by rotating the [DIAL].
The numeric keypad may be used to change the memory bank (identifier A, B,
C etc). The UP / DOWN keys may also be used to select the memory channel.
Alternatively you may enter the memory channel in full via the numeric keypad.
For instance, to recall memory channel "A23" press [1A] [2] [3] [ENT].
Once recalled, to delete the memory data from memory channel "A23" press
[FUNC] [9].
The memory channel will be deleted and the display will move upward or
downward (depending upon whether the UP or DOWN keys had been
previously used or direction of rotation of the [DIAL]) to the next memory
channel number which contains data.
Note: The delete key will be ignored when actually in SCAN or SEARCH
modes.

8-10 Deleting complete memory banks

It is often convenient to delete a whole memory bank in one operation. While
this may be accomplished by deleting each and every memory channel
individually as per section 8-9 of this manual, a faster method is available
especially if you have previously stored data into all 50 memory channels.
First place the receiver into the 2VFO operating mode
by pressing [2VFO].
Access the main "SELECT-DEL" by keying [FUNC]
[9]. Use the UP/DOWN or [DIAL] until the cursor is
to the left of the "MEMO-DATA" option then press
[ENT].