Connections On The Pcb - Duerkopp Adler 550-867 Service Instructions Manual

2.14 Connections PCB
Connection Device
X1 S401
X2 S411
X3 A40
X4 Jumper 1 - 2
Jumper 3 - 4
Jumper 5 - 6
X11 A20
X12 Y2
X13 Y3
X14 Y4
X15 Y5
X16 Y6
X17 Y7
X18 Y8
X19 P1
X20 A34
X21 A36
X22.1 .....................
X22.2 .....................
X22.3 .....................
X22.4 .....................
X22.5 .....................
X22.6 .....................
X22.7 .....................
X22.8 .....................
X23
X24 A38
X25 A39
J1 Solder bridge
For the sake of completeness, the various connections of the PCB
mentioned below are explained here.
Designation
Inductive switch hook plate
Reference switch stitch regulator
PCB Thread tensioner plate
Valve Y6 switch on with signal FA (default)
Valve Y6 switch on with signal NK
Valve Y6 switch on with signal FL
Distribution board in the control cabinet
Valve stroke position 1 (HP1)
Valve stroke position 1 (HP2)
Valve stroke position 1 (HP3)
Valve foot lifting (FL)
Valve blow clean residual thread monitor (RFW)
Valve needle cooler (NK)
Valve thread tension lifting (FS)
Speedomat
Key Block
Light barrier edge detection
+24-40V
Solenoid Y1 thread cutter (FA)
Signal Foot lifting (FL)
Signal Needle cooler (NK)
Solenoid Y12 thread clamp (FK)
+24-40V
+24-40V
0V Power
Hook thread monitor
Oil level gauge
closed = LED V4 on the key block
open = LED V1 on thread tension plate (default)
45