Fitting The Collecting Container; Electrical Connections - Duerkopp Adler 512/532 Operating Manual

Installation Instructions

8.3.7 Fitting the collecting container

Fig. 24: Fitting the collecting container
(1) - Screw
(2) - Bracket
(3) - Oil line
1. Place the bracket (2) in the drill hole on the table top (6) and fasten with
2. Bolt the oil catchment container (5) onto bracket (2).
3. Insert the oil line (3) into the oil catchment container (5)
4. Push the rubber supports (4) into the table top (6).
8.4
Operating manual 512/532 Version 01.0 - 03/2013
6
3 screws (1).

Electrical connections

DANGER
Risk of injury due to electrical current!
Unprotected contact with electrical current can
cause severe to fatal injuries.
ONLY qualified electricians, or persons with equiv-
alent training, may work on the electrical equip-
ment.
ALWAYS unplug from the mains before performing
any work on the electrical equipment.
1
2
3
4
5
(4) - Rubber support (in the oil catchment
tray)
(5) - Oil catchment container
53