4.12 Adapting Barcode Definitions - Duerkopp Adler 550-867 Service Instructions Manual

4.12 Adapting barcode definitions

96
In order to carry out changes in the barcode labelling system the
operator must be authorized to security level 2.
–
Log in to the system.
–
Call up "Check".
–
Call up "Setup".
–
Call up "Barcodes".
–
Select the corresponding type in the field "Primary barcode type".
This barcode is read via hand scanner.
–
Select the corresponding type in the field "Thread barcode type".
This selection applies to both needle and hook thread.
–
Select the corresponding type in the field "Endlabel barcode
type".
–
In the following fields masks can be defined to transmit
system-relevant information (entry: "1") and ignore unimportant
information (entry: "0"): "Prim. barcode identifier A" (barcode for
material and colour), "Prim. barcode identifier B" (barcode for the
top and bottom piece), "Prim. barcode identifier C" (barcode for
the seam pattern) and "Prim. barcode mask L/R" (barcode for the
left and right piece).