Duerkopp Adler 550-867 Service Instructions Manual page 76

72
Read bobbin no. with
stat. scanner
With seam scanner
Cone switch for the
needle thread
Cone switch for the
hook thread
Multibarcodes
With UPS monitoring
Needle control
Multibarcode switch
Save individual stitch data of
SAB-seam
Stitch counting with PC card
Efka decorative bartack
switched on
Thread tens. individual
stitch check
Calibration control
Thread tension graphic
Bobbin identification via
barcode (optional)
existing / not existing
Monitoring of the end label (optional)
existing / not existing
Monitoring of the thread cone
via proximity switch.
The barcodes are read with the hand
scanner.
existing / not existing
Monitoring of the thread
cone via proximity switch.
The barcodes are read with
the hand scanner.
existing / not existing
Entering additional barcodes besides
the primary barcodes
possible / not possible
possible / not possible
Regular control / exchange of the
needle
activated / deactivated
Automatic entering of additional
barcodes with batch mode
activated / deactivated
Saving the thread tension values
in a TXT-file
ON/OFF
The stitch counting of the PC
not of Efka is being considered
activated/ deactivated
Make selection according to Efka
parameter settings (decorative
bartack or regular bartack)
ON/OFF
Definition whether
the number of tolerance stitches in
a row should be outside of the
tolerance or be repartitioned over the
whole length
ON/OFF
Regular checking of the step motor
and the thread tension sensor
ON/OFF
Visualization of the thread tension
during the sewing process
ON/OFF