Duerkopp Adler 550-867 Service Instructions Manual page 77

Thread tension regulator on
Edge detection
Bartack stitches for each
SS progr.
"Values"
When this function is activated the scanners are selected, the barcode
type for the card-reader is defined and the desired number of barcode
digits is set.
When the function"Sew label separately" is activated in the
Components field, the number of stitches for the additional seam can
be set via the function "Number of stitches of label sewing "
In order to prevent that each thread that gets into the light barrier
simulates a strip the sensibility of the light barrier can be adjusted in
the function "Strip detection filter stitches" If the value 2 is entered
the size of the strip must be extended over two stitches in order to be
recognized as such.
Authorization for access to the system can be influenced by changing
the user level. The entered values represent the security levels that
are at least required in order to carry out the program functions.
In the field "Lot size" the number of sewing procedures, which should
be released by a singular scanning of the input barcode can be
determined.
When using an ETT nominal and
and actual values are compared and
corrected (adjusted)
ON/OFF
Optional equipment for the
detection / controlling of the
distance between needle and material
edge
existing / not existing
Enables different
Bartack stitches for initial or
end bartacks in the particular
seam sections
ON/OFF
73