Duerkopp Adler 550-867 Service Instructions Manual page 42

Hide thumbs Also See for 550-867:

Table of Contents

Correction

–

Loosen the screws (4x) on the clamping ring 5 and shift it towards

the hook bearing. Tighten the screws (4x) on the clamping ring 5

again in order to avoid changing the looping stroke's position.

–

Loosen the screws (2x) on the control cam 4.

–

Twist the lever 6 until it stops against the stop screw 13.

–

Set the distance between the control cam 4 (highest point) and the

roller 7 to 0.1 mm.

–

Tighten the screws (2x) on the control cam 4 again.

–

Loosen the clamping screw 8 on the control lever 6.

–

Twist the thread-pulling knife 1 so that the marking 14 of the

thread-pulling knife faces the blade of the counter-knife 2.

–

Tighten the clamping screw 8. Make sure not to allow any end

play.

–

Loosen the screws (4x) on the clamping ring 5 and shift it until it

stops against the control cam 4.

–

Fasten the screws (x4) on the clamping ring 5 again.

–

Check the looping stroke.

ATTENTION!

The control cam 4 and the clamping ring 5 serve mutually as stop and

should not be loosened at the same time!

Table of Contents

Show Quick Links

Table of Contents