6.9
Adjusting barcode definitions
The operator must have security level 2 in order to carry out changes
in the barcode labelling system.
–
Log on to the system.
–
Activate "Check" function
–
Activate "Setup" function
–
Activate the "Extended" function.
–
Select the required type in the "Primary barcode type" field.
This barcode is read into the system by the manual scanner.
–
Select the required type in the "Thread-barcode type" field.
The selection applies to both the upper and hook threads.
–
Select the required type in the "End-label barcode type" field.
–
Masks can be set in the "Primary-barcode identifier A" (material
and colour barcode), "Primary-barcode identifier B" (upper and
lower piece barcode), "Primary-barcode identifier C" (stitch type
barcode) and "Primary-barcode mask L/R" (left and right-piece
barcode) fields to pass on system-relevant information (entry: "1")
or ignore unimportant information (entry: "0").
1
55