Completing The Table Plate - DURKOPP ADLER 281 Operating Manual

54

7.4 Completing the table plate

The table plate belongs to the optional delivery scope.
Drawings are provided in  Appendix to allow you to
independently assemble a table plate.
Figure 31: Completing the table plate
③
④
(1) - Thread stand
(2) - Support
(3) - Lower hinge parts
1. Screw the drawer (4) in place with two brackets and six screws
(3.5 x 17) to the left, under the table plate.
2. Screw the oil pan (5) in place with eight screws (3.9 x 15) under
the recess for the machine.
3. Insert the support (2) into the hole.
4. Fit the lower hinge parts (3) into the recesses.
5. Fit the rubber corners (6) into the corner protrusions.
6. Insert the thread stand (1) into the hole.
7. Fasten the thread stand (1) with nut and washer.
8. Screw the thread reel holder and the unwinding bracket onto
the thread stand (1) in such a way that they are exactly parallel
above each other.
①
②
⑤
(4) - Drawer
(5) - Oil pan
(6) - Rubber corners
Operating manual 281 Version 06.0 - 05/2013
Set-up
⑥