Adjusting The Stitch Length - DURKOPP ADLER 281 Operating Manual

34

5.9 Adjusting the stitch length

The stitch length can be adjusted continuously by turning the
adjusting wheel (2). The adjusting mark (3) above the wheel
indicates the stitch length selected.
Use the stitch adjustment lever (1) to switch over to backwards
sewing. The stitch length is the same size for forwards and
backwards sewing.
Figure 18: Adjusting the stitch length
①
(1) - Stitch adjustment lever
Adjusting the stitch length
1. Turn the adjusting wheel (2)
• Larger stitch length:
Turn the adjusting wheel (2) counterclockwise.
• Smaller stitch length:
Turn the adjusting wheel (2) clockwise.
Sewing backwards/manual bartack
1. Slowly push the stitch adjustment lever (1) down as far as it
will go.
The stitch length is reduced. Backwards sewing starts
after the zero point. In the lower end position, the machine
sews backwards with the set stitch length.
(2) - Adjusting wheel for the stitch
length
Operating manual 281 Version 06.0 - 05/2013
Operation
③
②