Stand Installation; Installing Stand Parts; Completing Table Top And Fastening To The Stand - DURKOPP ADLER 381 Installation Instructions Manual

3. Stand installation

3.1 Installing stand parts

–
Install individual parts of the stand as shown in the illustration.
–
Slip-on the available stand feet 15.
–
Loosen slightly the screws 14 on both lateral and transversal struts 16 and ensure
that the stand stands safely.
The stand should rest on the ground with all its four feet!

3.2 Completing table top and fastening to the stand

–
Insert machine head support 1 into the bore-hole of the table top.
–
Insert the hinge bottoms 2 for the machine head into the recesses of the table top 4
and screw up.
–
Insert rubber corner 8.
–
Pull-in rest plugs 3 and slip-on pressure spring.
–
Screw drawer 5 with its holders on the left under the table top.
–
Screw main switch 12 on the right under the table top.
–
Screw cable duct 10 behind main switch 12 under the table top.
–
Screw the holder 9 for the strain relief of the connection cables behind the
cable duct 10 under the table top.
–
Screw the sewing lamp transformer 11 (additional equipment) under the table top.
–
Fasten the oil collector 13 in the table top recess by nails.
(For distance, see the sketch., nails in the accessories)
–
Fasten the table top 4 on the stand by wood screws (B8 x 35).(for position, see
the sketch)
–
Introduce the thread unwinder 7 into the bore-hole in the table topand fasten by
nuts and shims.
Fit and align thread reel holder and unwinder arm.
The thread reel holder and the unwinder arm should be vertically superposed..
–
Screw the holder for the oil can 6 to the left stand strut.
13
5